SparkFun Elektromechanica

toetsenpanelen Keypad - 12 Button

Magnetische schakelaars / Reedcontacten This small insulated reed switch can carry up to 0.8A and 0.35A to 0.5A while switched making it ideal for projects that require non-contact control. Reed switches are magnetically actuated electrical switches (not magically actuated though it seem

Solenoïden en actuatoren Solenoid, 5V, 2-pin JST PH Connector

Luidsprekers en omvormers If you want to get some sound out of your project but have a tight space budget this is a good way to do it. This 2.5W 4 Ohm speaker is only 28mm in diameter and just over 4mm thick. The cable is roughly 180mm long and terminates in a 2-wire JST co

Solenoïden en actuatoren Solenoids are a great way to induce linear motion for pushing pulling or controlling switches and levers. According to the datasheet this solenoid is rated for 36V but they work like a charm at 12V. We've been controlling them with the Arduino Power

DC-motoren Micro Gearmotor 90 RPM (6-12V)

Solenoïden en actuatoren 12V Solenoid Valve 3/4in

DC-motoren This is a simple 140RPM (no load) DC planetary gearmotor. This motor is great for various applications such as robotics electric locks household automation and small actuators.The supply voltage range is 6VDC - 24VDC with the polarity marker at

DC-motoren These micro gearmotors are incredibly tough and feature full metal gears. They have a gear ratio of 50:1 and operate up to 12 volts and have a stall torque of 20 oz-in. and a max speed of 460 RPM. Each micro gearmotor sports a 3mm D-shaft.Note: The m

Luidsprekers en omvormers Surface transducers give you the awesome power to turn almost any surface into a speaker. They're essentially just a speaker except instead of a cone the coil is attached to a pad that conducts the vibration into whatever you press it against. Hook

DIP-schakelaars / SIP-schakelaars A SMD DIP switch with 8 individual switch positions. Works great as general control switches.

Afstandhouders & tussenstukken These aluminum hex standoffs are 4.5mm across the flats. 16.0mm long and tapped through for a M2.5-0.45 screw. These are great for mounting pHATs to Raspberry Pi boards.Sold individually.